Dwyer Pitot - Dwyer Pitot
3 posts
• Page 1 of 1
by larrycavan » Tue Apr 11, 2006 4:12 pm
Ordered this from Dwyer recently. Price was right. Custom bend cost 25$ more.
- larrycavan
- Site Admin
- Posts: 1183
- Joined: Fri Apr 01, 2005 4:40 pm
by gofaster » Wed Apr 12, 2006 7:52 pm
What is the dimension across the "U" bend? The one I use is .850" with .125" tubing. Audie makes a 3/32" tube pitot, but I don't know the cross dimension. Can't remember if mine is from SF, Perf Trends or Dwyer.
Jim
- gofaster
- Posts: 237
- Joined: Fri Jul 01, 2005 6:39 pm
- Location: Indiana
by larrycavan » Thu Apr 13, 2006 11:04 pm
I'll measure it tommorow and post. Seem like it's 23mm if I recall correctly....I'll double check. There are areas I can't get to in some ports. I could use something less than .5" for certain heads..
Larry C
Larry C
- larrycavan
- Site Admin
- Posts: 1183
- Joined: Fri Apr 01, 2005 4:40 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests