Tractorsport Flowbench Forum Archive

Posted: **Mon Sep 19, 2005 5:51 pm**

What is everyone using for valve adjustment? I have seen a couple of different models you can purchase. Has anyone made their own? If so, do you have any pictures of the finished product?

Posted: **Mon Sep 19, 2005 6:17 pm**

Check this thread out for pics of various homemade adjusters:

Posted: **Tue Sep 20, 2005 12:26 am**

This works pretty well. A piece of 1/4" bar is bent a bit, and the arm from a magnetic base is bolted to it, close to where the bar is bolted to the stud/rocker bolt to keep deflection errors at a minimum. Drill and tap the adjusting bolt hole last to keep it from distorting while building the thing.

Tractorsport Flowbench Forum Archive

Valve adjustment