by blownalcohol » Sat Feb 10, 2007 1:49 pm
Well, I think I have decided to go with the vacuum motor setup. It just makes the most sense for me right now. I'm going to build the bench with a removable vacuum box which will allow me to go the blower route later should I decide to.
My question now is about wiring of the motors. I have searched "from the beginning" for some schematics of how people have wired their motors together...ideas on junction blocks, etc. and haven't found much. If someone knows of a thread I missed, let me know. If not, I would appreciate some input from guys who have done it. FYI.. I'm going to use 12 motors and probably build the box for 14, just in case.
Once again, thanks for everyone's help.
Newbie out.
Jeff Fagala
jdfperformance.com