meriam laminar flow elements?

Discussion on general flowbench design

Postby lewis » Fri Feb 23, 2007 1:46 pm

Anybody using these....I have some without calibration charts.
How would you guys calibrate them? Just looking at different ideas
lewis
 
Posts: 3
Joined: Mon Feb 06, 2006 5:24 pm
Location: Paw Paw ,MI

Postby Thomas Vaught » Sat Feb 24, 2007 2:22 pm

You can get a "As sold new" calibration chart for any laminar
element from Merriam Instruments if you take to the tech guys.

Having one recalibrated after a cleaning can be expensive but the piece would still be deadly accurate then.

If the element has not seen a hard dirty life then the existing calibration chart should be close.

Tom V.
Thomas Vaught
 
Posts: 465
Joined: Fri Feb 18, 2005 5:36 pm
Location: Michigan


Return to Flowbench General

Who is online

Users browsing this forum: No registered users and 4 guests