Any recommendation to what type of material (Alum, steel, wood)I should use for mounting the the test stand to the bench? Also what bolt pattern did you use to mount it to the bench?
Dave
test hole plate
2 posts
• Page 1 of 1
by bruce » Sun Jun 25, 2006 7:33 pm
I used a 1/4" thk 16" square steel plate with a 4-1/2" hole bored in it, the hold down bolts are on a 5" square bolt pattern. The "standard" is a 5" hole with the hold-down holes on the 5" square.
To clarify this would be the top of my bench and not the cylinder head adaptor. The head/carb, part to be tested adaptor could be made from almost anything depending on what you are testing, I have used alum, steel, pvc, clear acrylic and wood for my testing already.
Edited By bruce on 1151278589
To clarify this would be the top of my bench and not the cylinder head adaptor. The head/carb, part to be tested adaptor could be made from almost anything depending on what you are testing, I have used alum, steel, pvc, clear acrylic and wood for my testing already.
Edited By bruce on 1151278589
"There is no more formidable adversary than one who perceives he has nothing to lose." - Gen. George S. Patton
- bruce
- Site Admin
- Posts: 1638
- Joined: Sun May 09, 2004 12:17 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests