New cylinder hone.

Place to post other shop equipment ideas or something you made and u'd like to share?

Postby racear2865 » Wed Oct 04, 2006 11:22 pm

Scott
again
racear2865
 
Posts: 9
Joined: Sun Apr 23, 2006 11:32 pm
Location: murfreesboro

Postby racear2865 » Wed Oct 04, 2006 11:23 pm

and again. Have other pictures if you are interested
reed
racear2865
 
Posts: 9
Joined: Sun Apr 23, 2006 11:32 pm
Location: murfreesboro

Postby Greg » Fri Oct 06, 2006 5:29 pm

Racear, thanks for the pictures. Would you mind posting the schematics for the air system, yours looks a lot less complicated than what I have seen on the Rottler hones!

I'm making up a dummy hone this weekend to set everything up on and check out some ideas I have been thinking out over the last couple of months. Also, what diameter ram did you end up using on yours? I have a ram about 80mm diameter bore and 30mm shaft which I think will do the job.

Greg.
Greg
 
Posts: 115
Joined: Thu Jan 22, 2004 3:24 am
Location: Queanbeyan, Australia

Previous

Return to Other DIY shop equipment

Who is online

Users browsing this forum: No registered users and 11 guests