Posted:
Wed Oct 04, 2006 11:23 pm
by racear2865
and again. Have other pictures if you are interested
reed
Posted:
Fri Oct 06, 2006 5:29 pm
by Greg
Racear, thanks for the pictures. Would you mind posting the schematics for the air system, yours looks a lot less complicated than what I have seen on the Rottler hones!
I'm making up a dummy hone this weekend to set everything up on and check out some ideas I have been thinking out over the last couple of months. Also, what diameter ram did you end up using on yours? I have a ram about 80mm diameter bore and 30mm shaft which I think will do the job.
Greg.