
Posted:
Wed Dec 17, 2008 5:32 pm
by madman
I am new to this site,. Yet If i start to think a bit arent intake charges full of Air and Fuel also? Is it accurate to do air flow only ? when fuel and air are mixed entering the Cylinder Head? Has anyone done a Wey Flow type porting? Just Curious thanx mike aka Madman

Posted:
Wed Dec 17, 2008 7:37 pm
by blaktopr
Since I been using it, wet testing has been a tool I allways incorporate. You can find (most results) from dry only. Wet can help the learning curve, IMO. Check in the Wetflow section.