Tractorsport Flowbench Forum Archive

Posted: **Thu Mar 20, 2008 7:33 pm**

Hi all

I want start to build a PTS Flowbench, but I,m asking myself how is the accuracy about water nanometer, its because for start I want use water nanometer then I will make myself....

I need to tell too, to stay honest... it will be the first time I will work with flowbench for research about flow.

my research is based for small block cylinder head Chevy, Ford...

I know the time to setup with water nanometer is a big way but I,m not ready for this moment to go with FP1 box ,,my budget for now don't allow me to buy now,,, but I plan to buy at the next level...

I want start to use my Flowbench with water nanometer.
for the read,, I will see later,,, for now I want use my own water nanometer,,, How much it cost? for a good water nanometer.
I think I will need more then one,,,,

can someone can help me or have a suggestion about that,, I,m very confuse,,I have never work with flowbench and I don't know how realy read that,,,
I know I have need program calculator to convert my read from nanometer to convert at CFM, what program I need?

AND I plan to build my own Flowbench,, trust me I will,, :;):

Hope someone can help me !
Aztec

Posted: **Thu Mar 20, 2008 9:36 pm**

Posted: **Thu Mar 20, 2008 10:20 pm**

Just a follow-up Aztec purchased a set of PTS plans so he now has access to the PTS plans area and a set of plans will be shipped out to him soon.

Posted: **Fri Mar 21, 2008 5:21 pm**

Thanks Larry, very helpful . I have find alot of stuff on that,, :;):
and thanks for the spreed sheet, I will study that....
Thanks Bruce,,,,

Posted: **Fri Mar 21, 2008 6:19 pm**

Tractorsport Flowbench Forum Archive

Water nanometer