Page 1 of 1
Posted:
Sun Jan 29, 2006 1:30 pm
by Scott
Heres a couple of pics of my first pitot bench, whipped together in a few afternoon's....
Posted:
Sun Jan 29, 2006 1:38 pm
by Scott
Depression control via. machined pvc slide valve...
Posted:
Sun Jan 29, 2006 1:39 pm
by Scott
Flow Element........
Posted:
Sun Jan 29, 2006 6:42 pm
by Thomas Vaught
Very nice.
Tom V.
Posted:
Sun Jan 29, 2006 10:20 pm
by Nick
What does the quote on the wall say? My life may not be the same if I do not know. Must have input.
Nick
Posted:
Sun Jan 29, 2006 10:21 pm
by Jesse Lackman
I don't think it says anything about Jessica....
Posted:
Sun Jan 29, 2006 10:31 pm
by Scott
"I owe my success to having listened respectfully to the very best advice, and then going away and doing the exact opposite."(unknown)
Posted:
Mon Jan 30, 2006 10:56 pm
by blown928
Nice! Does it suck & blow? What are you using for motors? What are you getting for depression out of it? What are you using for AC power? Inquiring minds.....
Posted:
Tue Jan 31, 2006 9:05 pm
by Scott
I just use the trusty shop vac for the air mover, It will go either direction by just rotating the averaging pitot 180 degrees and switching to the blow side of the shop vac.It will pull about 9" across a 1.454"dia test orifice and read 81% on my inclined.
Scott