Blow-By Gauge for Performance Trends

Postby fchp » Sun Jun 17, 2007 10:13 pm

I'm currently using a 0-100SCFH acrylic flow meter to measure my engine blow-by. I would like to have a gauge I can incorporate into my Datamite & Performance Trends software so I can log it.

Help.
fchp
 
Posts: 16
Joined: Fri Aug 13, 2004 10:22 pm
Location: Macclenny, FL

Postby DaveMcLain » Mon Jun 18, 2007 9:39 am

I've wanted to add a blow by meter to my dyno setup after seeing one in a Vizard book some time ago. It would be cool to log the data but I think having a simple one like you have just hanging somewhere where it can be seen easily would be very cool. I have an engine here right now that belongs to a customer and I'm pretty sure it would peg out your meter! It would be good to be able to give him a quantity of blowby number at some rpm say peak torque.
DaveMcLain
 
Posts: 110
Joined: Sat Jan 01, 2005 10:30 am
Location: Cuba MO  USA


Return to Dyno Discussion II

Who is online

Users browsing this forum: No registered users and 6 guests