Page 1 of 1
Posted:
Fri Jun 22, 2007 7:30 amby 99-1134301289
hello I have a blower in a corner of my garage I do not know yet what I will do with but I keep it for a future project of flowbench
cre
Posted:
Fri Jun 22, 2007 3:08 pmby riga team
Posted:
Fri Jun 22, 2007 3:09 pmby riga team
good blower. how much CFM You want flow? For 400-600 CFM You will need blower 450-500 mm. RPM You will need 5000. Your blower must be about 7000-8000 RPM, but on 28" maybe will be troubles and problems.
Anatoly
Posted:
Fri Jun 22, 2007 5:51 pmby Tony
That is a beautiful very well proportioned blower cre, it should make a fantastic flow bench blower.
And it looks brand new !
Posted:
Sat Jun 23, 2007 8:03 amby 99-1134301289
Yes, it is as new it come from a French company which works for the aerospace one close to the town of Bordeaux it almost finished in the dustbin because of the broken down electric motor the person who gave it to me had a very good idea for the moment I have a flowbench with orifice plate in project with 6 vacuum cleaner motor but in the future I would like to build another flowbench of the Pitot type with a flow element of 2 or 2.5 inches for a maximum of 400 cfm I think that this blower will be perfect
Posted:
Sat Jun 23, 2007 5:57 pmby Tony
It will be perfect, but it will need to be run at a fairly high operating rpm to reach sufficient pressure. An excellent find cre.
Posted:
Sun Jun 24, 2007 6:42 pmby Thomas Vaught
I agree with Tony that you will need to fine tune the pulley ratio/ blower speed to get the air flow and test pressure you need BUT you have a fine flow bench part there.
Tom V.