Page 3 of 3
Posted:
Wed Sep 09, 2009 7:17 pmby Flash
I noticed that you didn't paint the inside of your bench. could the area be seeping through the mdf?
Is the motor plate, mdf, sealed all the way around its 4 corners?........... Make that 8 corners................
Posted:
Thu Sep 10, 2009 10:15 amby emarsh
Posted:
Thu Sep 10, 2009 12:17 pmby bruce
The plans call out specifically painting the inside of the panels, MDF will loose a good amount of air. There is a post on here showing MDF bubbling up a soap spray solution that was sprayed onto one of the panels on someone's flowbench.
Posted:
Fri Sep 11, 2009 11:07 amby emarsh
I'd sealed the outside of the box but missed the fact that the inside needs to be coated too. I'll take a shot at it and see what happens.
Posted:
Thu Oct 08, 2009 7:28 pmby fast_crew
Was wondering if there is any update on your bench Emarsh did this take care of the low pressure issues??
Posted:
Sun Oct 11, 2009 11:20 amby emarsh
No, I've sealed the inside and that doesn't seem to have any effect. With the 300 CFM plate in place I can just about pull 28". I'm starting to think that I might have to buy another motor.
Posted:
Sun Oct 11, 2009 12:02 pmby Flash
Posted:
Wed Oct 21, 2009 11:39 amby blaktopr
Emarsh. Where is your bench. In the house or in a garage. If in the garage, how far is it from the house?? Does it have it's own service drop or is it fed from the house/main structure? You will get different results depending on these facctors. Bruce has about 25 feet of feeder from his main panel. Where then someone like me has about 75 feet from house to garage. Then another 20 feet from subpanel in garage to subpanel for the bench. Add in wire size, amount of connections, and voltage from the street, can add up to net you a lesser air result. I have Surplus motors and need 5 for 285 to 295 CFM. 8 motors for 350. I see this with even running power tools on job sites. Long cords, small guage wire, or even a low output from a generator will change how much power the tool will have.
Posted:
Thu Oct 22, 2009 3:00 amby coulterracn
Posted:
Fri Oct 23, 2009 3:24 pmby blaktopr
Here is another one for ya. Slider plate leak. Mine has it pretty bad. Now all I have to do is find a way to fix this. My box is different than yours though cause it is a separate unit and built with datos. (My own design) Then when it was assembled, some pieces "shifted".
Posted:
Fri Oct 23, 2009 4:18 pmby jfholm
The slider plate leakage could act like a fuel pressure bypass and bypass air pressure either direction and only allow you to attain a certain pressure. This might be especially noticable with smaller capacity motors.
Posted:
Fri Oct 23, 2009 7:43 pmby blaktopr
I shimmed the intake side, somehow it got a little larger there. Snuck a thin steel plate in there with another hole. I am up to 365@34". Using the DM plate in the bench. Next time I have to assemble something like this more carefully.
Posted:
Fri Oct 23, 2009 11:12 pmby bruce
Posted:
Sat Oct 24, 2009 12:07 amby blaktopr