Plan highlights

Plan highlights, future thoughts

Postby bruce » Fri Nov 09, 2007 10:39 pm

Plans require 2-1/2 pieces of 3/4" thick 4 x 8 sheet of MDF or equivalent for the panels.

Only moving part inside the bench besides the blower motors is the flow direction slider plate, no valves or rotating orifice disks to worry about sealing.

CFM range changes if needed are made by changing out the single orifice plate through an 8" access hole cut in the front, side or rear panel which is covered with a Deck Plate or a fabricated cover of your own design.




Edited By bruce on 1194747434
"There is no more formidable adversary than one who perceives he has nothing to lose." - Gen. George S. Patton
bruce
Site Admin
 
Posts: 1638
Joined: Sun May 09, 2004 12:17 pm

Return to Plan info

Who is online

Users browsing this forum: No registered users and 1 guest

cron