Water Gages?

Plan highlights, future thoughts

Postby bruce » Thu Jan 17, 2008 9:56 am

Currently under development and I personally tested on a customer PTS bench build is this inclined manometer. This inclined manometer hooked to his bench and with minor tweaking flowed within 1% of the Pass-Around-Plates! I'm sure if I had spent more time it could be tweaked to read "on-the-numbers" (I will be doing this on my personal PTS bench in the very near future). I can confirm without a doubt the bench plans work and work quite well I might add with DIY water gages!

Image

Once I get all the details worked out I'll be offering info on building water gages with the plans along with orifice sizes to work with the gages.
"There is no more formidable adversary than one who perceives he has nothing to lose." - Gen. George S. Patton
bruce
Site Admin
 
Posts: 1638
Joined: Sun May 09, 2004 12:17 pm

Return to Plan info

Who is online

Users browsing this forum: No registered users and 1 guest

cron