Update on FlowSoft and the PTS-DM
Bruce and I have had a couple of extensive conversations about the DM, flow bench functionality and motor sizing. With the Surplus Center motors gone and the next best motor out there at 3 to 4 times it cost the motors are now becoming even a bigger factor in bench sizing. At the current time FlowSoft is configured to function under a 16" Delta P, But could go down as far as 8 or so depending on the sensors available or if someone was doing a small bench say 2 motors.
Rick
FlowSoft - The Scoop on the PTS-DM with FlowSoft
26 posts
• Page 2 of 2 • 1, 2
by stef-1 » Mon Mar 30, 2009 1:45 pm
Can it be usable for people using very low deltap's on small benches? Like 10" test pressure with 2.5" deltap across the orifice...
Other thing that may be useful... if you have the ability to input either valve o.d or seat i.d/angle with lift you could show the discharge coefficient on the fly, which after all is what we're really interested in
Output to an excel compatible file I like. Can it output for multiple tests at a time e.g. if I test a port at 10" test pressure then 15", 20", 25", etc. I can use this to generate a 3d contour map of the port e.g. cd vs lift vs pressure ratio. This can be used as input into an engine simulation or used to spot problems with the port.
Other thing that may be useful... if you have the ability to input either valve o.d or seat i.d/angle with lift you could show the discharge coefficient on the fly, which after all is what we're really interested in
Output to an excel compatible file I like. Can it output for multiple tests at a time e.g. if I test a port at 10" test pressure then 15", 20", 25", etc. I can use this to generate a 3d contour map of the port e.g. cd vs lift vs pressure ratio. This can be used as input into an engine simulation or used to spot problems with the port.
- stef-1
- Posts: 79
- Joined: Thu Jan 31, 2008 8:48 pm
by otto69 » Mon Oct 12, 2009 8:11 am
Thanks Rick
No I dont have any at the moment. Looking at purchasing Bruce's DM, plans and plates in the near future and was wondering if the software had upgrades / additions.
What sort of enhancements were you thinking of ??
cheers
Clayton
No I dont have any at the moment. Looking at purchasing Bruce's DM, plans and plates in the near future and was wondering if the software had upgrades / additions.
What sort of enhancements were you thinking of ??
cheers
Clayton
- otto69
- Posts: 2
- Joined: Fri Dec 09, 2005 6:15 am
- Location: Australia
by jfholm » Mon Oct 12, 2009 11:48 pm
[quote="1960FL"][color=#000000]So here is the plan, to make the PTS-DM and FlowSoft usable by those that do not currently run a 16
It is a wise man that learns from his mistakes, but it is a wiser man that learns from the mistakes of others.
- jfholm
- Posts: 453
- Joined: Sat Jan 17, 2009 7:12 pm
- Location: Utah, USA
by bruce » Tue Oct 13, 2009 6:30 am
We've talked about it but been to busy with other things that no actual testing has been done on this yet to see what really needs to be done.
Bruce
Bruce
"There is no more formidable adversary than one who perceives he has nothing to lose." - Gen. George S. Patton
- bruce
- Site Admin
- Posts: 1638
- Joined: Sun May 09, 2004 12:17 pm
26 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 1 guest