MSD bench mods

Orifice Style bench discussions

Postby Mouse » Tue Apr 26, 2005 12:43 pm

It depends on how you define "fairly accurate". Some people may look at the 20.1 - 20.7 as completely unacceptable. This test was done under ideal conditions so what acctually happens inside a settling chamber may be different. I have a unit under beta testing now.

John
Mouse
 
Posts: 308
Joined: Wed Jan 21, 2004 8:45 pm

Postby larrycavan » Mon May 09, 2005 8:08 am

John,

How did you make out with this project?

Larry
larrycavan
Site Admin
 
Posts: 1183
Joined: Fri Apr 01, 2005 4:40 pm

Postby Mouse » Mon May 09, 2005 2:36 pm

Hi Larry,

No reports yet. The FP1 is presently being shipped with 6 different size/Cf orifice processing capability anyway. Just how big of a single orifice will work is still not known, but will most likely depend on the design of the bench settling chambers, baffling and air path.

Thanks for asking

John
Mouse
 
Posts: 308
Joined: Wed Jan 21, 2004 8:45 pm

Postby larrycavan » Sun May 15, 2005 11:56 pm

Mouse,

Take a close look at the attached photo. I'ts a picture of the MSD flow disk. Look at the way the orifice being measured sits in a little chamber. I would think that's got to raise the flow.

Larry
larrycavan
Site Admin
 
Posts: 1183
Joined: Fri Apr 01, 2005 4:40 pm

Previous

Return to Orifice Style bench discussion

Who is online

Users browsing this forum: No registered users and 5 guests