It depends on how you define "fairly accurate". Some people may look at the 20.1 - 20.7 as completely unacceptable. This test was done under ideal conditions so what acctually happens inside a settling chamber may be different. I have a unit under beta testing now.
John
MSD bench mods
34 posts
• Page 3 of 3 • 1, 2, 3
by Mouse » Mon May 09, 2005 2:36 pm
Hi Larry,
No reports yet. The FP1 is presently being shipped with 6 different size/Cf orifice processing capability anyway. Just how big of a single orifice will work is still not known, but will most likely depend on the design of the bench settling chambers, baffling and air path.
Thanks for asking
John
No reports yet. The FP1 is presently being shipped with 6 different size/Cf orifice processing capability anyway. Just how big of a single orifice will work is still not known, but will most likely depend on the design of the bench settling chambers, baffling and air path.
Thanks for asking
John
- Mouse
- Posts: 308
- Joined: Wed Jan 21, 2004 8:45 pm
by larrycavan » Sun May 15, 2005 11:56 pm
Mouse,
Take a close look at the attached photo. I'ts a picture of the MSD flow disk. Look at the way the orifice being measured sits in a little chamber. I would think that's got to raise the flow.
Larry
Take a close look at the attached photo. I'ts a picture of the MSD flow disk. Look at the way the orifice being measured sits in a little chamber. I would think that's got to raise the flow.
Larry
- larrycavan
- Site Admin
- Posts: 1183
- Joined: Fri Apr 01, 2005 4:40 pm
34 posts
• Page 3 of 3 • 1, 2, 3
Return to Orifice Style bench discussion
Who is online
Users browsing this forum: No registered users and 8 guests