Tractorsport Flowbench Forum Archive

Posted: **Thu Jun 01, 2006 3:30 pm**

I have most of the components for a Bear Autorol Chassis Dyno for cars. The chassis has been flame cut to separate it into two halves. the unit has four 8 inch rolls and a large air over haydraulic brake. there is no cover to the brake enclosure. It appears to be water cooled were it to have a cover. I have the control panel as well. it is on a 3 ft by 1.5 ft wide roller box with doors and shelves underneath.

This would take some work to put in original condition but prbably has some good parts for a DIY dyno.

If you can haul it out of here, you can have it.

Thanks.

Posted: **Thu Jun 01, 2006 4:03 pm**

And it would be located where?

Posted: **Thu Jun 01, 2006 4:37 pm**

More than likely not close to me I bet

Posted: **Thu Jun 01, 2006 8:09 pm**

Is it within easy walking distance of Australia ?

Posted: **Fri Jun 02, 2006 8:50 pm**

Located in Newton, New Hampshire.

Walkable as soon as the bridge linking Melbourne and LA is complete. :;):

Posted: **Sat Jun 03, 2006 5:42 pm**

I knew it would not be in Australia, as no one ever upgrades here, then just gives away the old one:D

Tractorsport Flowbench Forum Archive

Free Chassis Dyno Project!