Chassis dyno

General Dyno discussion (read only) please make any new posts in the new Dyno forum

Postby rab » Sun Apr 23, 2006 5:41 pm

Looking for help to work out what size rollers I would need for a chassis dyno to test 4stroke karts and Junior dragsters.

Rick
rab
 
Posts: 9
Joined: Wed Nov 23, 2005 5:11 pm
Location: Australia

Postby rab » Sun May 21, 2006 6:14 pm

Still looking for some idears, Inertia chassis dyno or brake/ TQ arm chassis dyno??
rab
 
Posts: 9
Joined: Wed Nov 23, 2005 5:11 pm
Location: Australia

Postby Tony » Mon May 22, 2006 7:20 pm

The larger the roller diameter the better. The ground is flat, but coupling power into a highly curved roller by frictional grip is going to be much less efficient. The smaller the roller diameter the worse it is.

Inertia dyno is simple, but potentially dangerous. Not being able to hold constant Rpm is a very great disadvantage for engine tuning or engine development work, but fine for just testing final power.

A water brake, or an eddy current absorber would be best. A friction brake might work too, but could be tricky to control properly with a peaky engine.
Also known as the infamous "Warpspeed" on some other Forums.
Tony
 
Posts: 824
Joined: Sat Dec 03, 2005 12:34 pm
Location: Melbourne, Australia


Return to General Dyno discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron