Posted:
Wed Feb 01, 2006 11:30 pmby wing64k
When measuring a port with calipers is there an industry standard where to measure,for example should the ssr be measured at the center or more towards the seat or inlet or say for the throat at the base of the seat or closer to the valve at the bottom angle.
Dean
Posted:
Thu Feb 02, 2006 9:41 amby larrycavan
Dean
I personally measure the port lengths from the bottom of the seat cut and the throat diameter at it's smallest point which is generally at the bottom of the inside cut.
I'll email you a paper on different ways to measure port areas.
Larry C
Posted:
Thu Feb 02, 2006 10:31 amby Mousehouse1
Can you send that paper to me as well Larry?
Posted:
Sat Feb 04, 2006 5:01 pmby Scott
Larry, would you be so kind.....me too