filler?

Discussion on flowbench testing techniques "top secret" ideas . . .

Postby blown928 » Mon Mar 06, 2006 9:44 am

What is suitable to use for a filler material inside the intake ports? I've found a dimple in the intake side where flow increases if I fill it with a tiny bit of clay. Will 2 part epoxy hold up to the temperatures seen there? Maybe JB Weld?

I'm sure exhaust is tougher due to the higher temperatures. Any suggestions for filler there?
Bill
'84 928s 5 sp. Vortech/749
blown928
 
Posts: 51
Joined: Fri Oct 28, 2005 9:03 pm
Location: Southern New England

Postby Nick » Mon Mar 06, 2006 12:47 pm

You may want to look over on the speed talk forum. JB weld seams to be popular.


Nick
Nick
 
Posts: 144
Joined: Thu Oct 13, 2005 9:27 pm
Location: Yakima WA


Return to Flowbench techniques

Who is online

Users browsing this forum: No registered users and 3 guests