Posted: Mon Dec 01, 2008 10:18 pmHello, I'm new here my name is Shane. I have been using and selling an epoxy called Smooth-On Metalset A4
I've been using it for more then ten years now and from my own experience and from the feedback I have received its all been positive I have use it extensively in
two-stroke work port shaping, case stuffing etc. I have also used it for some intake port and manifold work on some turbo charged Aussie V6 cylinder heads with no problems after some 30 plus runs and countless street kilometres the epoxy is still holding strong.
I place it with a scribe and or a knife then use some acetone to smooth it out I then let it set off for 24hr it sets in about 20min at 25c
but I have always let it set off for 24hrs and then I place it in an oven at 100c for about 30min remove let it cool and start grinding..
I've been using it for more then ten years now and from my own experience and from the feedback I have received its all been positive I have use it extensively in
two-stroke work port shaping, case stuffing etc. I have also used it for some intake port and manifold work on some turbo charged Aussie V6 cylinder heads with no problems after some 30 plus runs and countless street kilometres the epoxy is still holding strong.
I place it with a scribe and or a knife then use some acetone to smooth it out I then let it set off for 24hr it sets in about 20min at 25c
but I have always let it set off for 24hrs and then I place it in an oven at 100c for about 30min remove let it cool and start grinding..