Reversing flow??

Discussion on general flowbench design

Postby UKDoug » Fri Jan 16, 2009 6:33 pm

On an orifice type bench what is the best/simplest way for reversing flow??

Thanks,

Doug.
UKDoug
 
Posts: 54
Joined: Sun Jul 27, 2008 4:00 pm

Postby thomasvaught-1 » Fri Jan 16, 2009 10:26 pm

Two boxes:

One Box with the orifice plate and the head fixture on it.

The second box has a two chambers with a dividing wall in the in the center that the vacuum motors mount on. Two openings on the "Motor box". The Motor box has casters to allow spinning the motor box around.

To test intake, hook a pipe from the "orifice box" to the intake side of the "motor box"

To test exhaust hook the pipe from the "orifice box" to the exhaust side of the "motor box"

Somewhere on the "Pipe" have a bleed valve to control test pressure in the orifice box.

That is about as simple as it gets.

Tom Vaught
thomasvaught-1
 
Posts: 172
Joined: Sun Jan 20, 2008 9:44 pm


Return to Flowbench General

Who is online

Users browsing this forum: No registered users and 4 guests