side valve valve ajuster

Discussion on flowbench testing techniques "top secret" ideas . . .

Postby rbracer » Thu Mar 04, 2004 6:14 pm

Looking For any ideas for a tool to check valve lift on a side valve industrial engines wile flow testing
rbracer
 
Posts: 11
Joined: Tue Mar 02, 2004 5:26 pm

Postby willeng » Sat Mar 06, 2004 9:37 pm

rbracer:

You could get a micrometer mechanism & connect this to a small vertical slide with a right angle bracket on the bottom, maybe with a small slot in the end to fit the valve stem groove.

You could bolt this to the engine somehow for stability & position the right angled arm on the valve stem & turn the micrometer mechanism to adjust valve lifts.

If you need a quick drawing send us an E-mail
willeng
 
Posts: 14
Joined: Fri Feb 13, 2004 1:59 am

Postby 98-1074649673 » Sat Mar 06, 2004 10:39 pm

Here is how I do it on my flathead engines.
Image
Image

Should be self explanitory on how it works. Probably a tight fit on a Briggs block, works well on the cast iron Kohlers I work with. I have to come up with a similar setup to work on the Briggs 12hp alum block flatheads for engine development work I am getting into in the near future for the USLMRA racing tractor series.
98-1074649673
 

Postby rbracer » Tue Mar 09, 2004 5:20 pm

Thanks for th idears will give them a try
rbracer
 
Posts: 11
Joined: Tue Mar 02, 2004 5:26 pm

Postby Shawn L » Fri Mar 12, 2004 2:25 pm

Hey all,
What is a good model and or p/n for an accurate yet inexpensive dial gauge similar to the above one?
Shawn L
 
Posts: 14
Joined: Fri Jan 23, 2004 11:18 am

Postby 98-1074649673 » Fri Mar 12, 2004 3:14 pm

The one in the pic is from Harbor Freight on sale for $6.99. I had to cut the back lug off for my application. Simple, cheap and accurate enough for my application. I didn't care to destroy an expensive dial indicator for my setup. Hope that helps . . .
98-1074649673
 


Return to Flowbench techniques

Who is online

Users browsing this forum: No registered users and 9 guests